Root Galaxy S3 I9300 On Official XXELLB Android 4.1.2 Jelly Bean Firmware

Galaxy S3 I9300 can be rooted on official XXELLB Android 4.1.2 Jelly Bean firmware. XXELLB Android 4.1.2 Jelly Bean firmware has been rolled out in Saudi Arabia by Samsung, go through the guide to manually update official XXELLB Android 4.1.2 Jelly Bean Firmware On Galaxy S3 I9300.

To root Galaxy S3 I9300 we will be using CF-Auto-Root Package. Rooting voids warranty of your device which can be regained only after installing official firmware update.

Rooting of device will enable you to flash ROMs which require root access.

The guide mentioned below is only for Galaxy S3 I9300 and is not compatible with any other device. To know the model number of your device go to Settings >> About Phone.

We cannot be held liable of any damage done to your device while following the below mentioned procedure.

Galaxy S3

Root Galaxy S3 I9300 on official XXELLB Android 4.1.2 Jelly Bean firmware

Take a complete backup of data,apps and settings as the procedure may wipe your data.

Make sure that the battery of device has a minimum charge of 60%.

Enable “USB debugging” on your device by going to Settings >> Developer options >> Enable USB debugging.

Download Kies Software to install drivers.

Download Root Package for Galaxy S3 I9300 (CF-Auto-Root-m0-m0xx-gti9300.zip) and Odin (Odin307.zip).

Extract the Firmware file which you have downloaded in above step. You will get “.tar” file along with other files.

Extract Odin to get “Odin3 v3.07.exe” file.

Switch off device.

Boot device into download mode. Press and hold Volume Down, Home, Power till device turns on and then press Volume Up to enter download mode.

Connect device to computer using USB cable. Odin will detect your device and ID:COM will turn yellow and a message appears saying “Added”. Re-install drivers if Odin fails to detect device.

Click on “PDA button” in Odin and navigate to select “.tar″ file which you have downloaded.

In Odin make sure that “Auto Reboot” and “F.Reset Time” are selected and “Re-Partition” check box is unchecked.

Click on Start button in Odin to start flashing Android 4.1.2 Jelly Bean firmware. When flashing is complete you will get a PASS message.

Disconnect device from your computer and let it boot automatically.

You have rooted Galaxy S3 I9300 on official XXELLB Android 4.1.2 Jelly Bean firmware. You can check if your device is rooted by installing “Root Checker” from Google Play.

Leave a Reply

Your email address will not be published. Required fields are marked *