Install XXKTT Android 2.3.6 Gingerbread Firmware on Galaxy Gio S5660

S5660XXKTT Android 2.3.6 Gingerbread for Galaxy Gio S5660 is available for a download. The update can be installed via Kies Software or you can also go through the step by step guide to install XXKTT Android 2.3.6 firmware update on your Galaxy Gio S5660. Remember, this is an official firmware update and hence your device will lose root and other installed Custom ROMs. The firmware is available for regions which includes Austria, Belgium, France, Germany, Hungary, Italy, Spain, United Kingdom.

Firmware details:

Android version: 2.3.6
PDA: S5660XXKTT
CSC: S5660KPPKT4
Regions: Austria, Belgium, France, Germany, Hungary, Italy, Spain, United Kingdom

The guide mentioned below is only for Galaxy Gio S5660 and is not compatible with any other device. To know the model number of your device go to Settings >> About Phone.

We cannot be held liable of any damage done to your device while following the below mentioned procedure.

Galaxy Gio S5660

Install XXKTT Android 2.3.6 Gingerbread firmware on Galaxy Gio S5660

Take a complete backup of data,apps and settings as the procedure may wipe your data.

Make sure that the battery of device has a minimum charge of 60%.

Enable “USB debugging” on your device by going to Settings >> Developer options >> Enable USB debugging.

Download Kies Software to install drivers.

Download XXKTT Android 2.3.6 Gingerbread (S5660XXKTT_S5660KPPKT4_KPP.zip) update on Galaxy Gio S5660 and Odin (Odin307.zip).

Extract Odin to get “Odin3 v3.07.exe” file.

Switch off device.

Enable “USB debugging” on your device by going to Settings >> Developer options >> Enable USB debugging.

Switch off device.

Boot device into download mode. Press and hold Volume Down, Home, Power till device turns on and then press Volume Up to enter download mode.

Connect device to computer using USB cable. Odin will detect your device and ID:COM will turn yellow and a message appears saying “Added”. Re-install drivers if Odin fails to detect device.

Click on “PDA button” in Odin and navigate to select “.tar″ file which you have downloaded.

In Odin make sure that “Auto Reboot” and “F.Reset Time” are selected and “Re-Partition” check box is unchecked.

Click on Start button in Odin to start flashing Android 2.3.6 Gingerbread. When flashing is complete you will get a PASS message.

Disconnect device from your computer and let it boot automatically.

XXKTT Android 2.3.6 Gingerbread firmware on Galaxy Gio S5660 is installed. You can check firmware version by going to Settings >> About Phone.

Leave a Reply

Your email address will not be published. Required fields are marked *