Install Official ZCALL3 Android 4.1.1 Firmware For Galaxy Camera EK-GC100

Samsung has rolled out ZCALL3 Android 4.1.1 Jelly Bean firmware update for Galaxy Camera EK-GC100 in China. The new firmware update can be installed OTA or by using Kies. Those who want to install ZCALL3 Android 4.1.1 Jelly Bean manually on Galaxy Camera EK-GC100 can go through the guide mentioned below.

This is an official firmware update from Samsung, so your device will lose root and other Custom ROMs which you installed.

Firmware Details:

Android version: 4.1.1 Jelly Bean

The guide mentioned below is only for Samsung Galaxy Camera model number EK-GC100 and cannot be tried on any other device.To know the model number of your device go to Settings >> About Camera.

We cannot be held liable of any damage done to your device while following the below mentioned procedure.

Galaxy Camera

Install official ZCALL3 Android 4.1.1 firmware update for Galaxy Camera EK-GC100

Take a complete backup of data,apps and settings as the procedure may wipe your data.

Make sure that the battery of device has a minimum charge of 60%.

Enable “USB debugging” on your device by going to Settings >> Developer options >> Enable USB debugging.

Download Kies Software to install drivers.

Download ZCALL3 Android 4.1.1 firmware ( for Galaxy Camera EK-GC100 and Odin (

Extract the Firmware file which you have downloaded in above step. You will get “.tar” file along with other files.

Extract Odin to get “Odin3 v3.07.exe” file.

Switch off device.

Boot device into download mode. Press and hold Volume Down, Home, Power till device turns on and then press Volume Up to enter download mode.

Connect device to computer using USB cable. Odin will detect your device and ID:COM will turn yellow and a message appears saying “Added”. Re-install drivers if Odin fails to detect device.

Click on “PDA button” in Odin and navigate to select “.tar″ file which you have downloaded.

In Odin make sure that “Auto Reboot” and “F.Reset Time” are selected and “Re-Partition” check box is unchecked.

Click on Start button in Odin to start flashing Android 4.1.1 Jelly Bean firmware. When flashing is complete you will get a PASS message.

Disconnect device from your computer and let it boot automatically.

You have installed official ZCALL3 Android 4.1.1 firmware update for Galaxy Camera EK-GC100. You can check firmware version by going to Settings >> About Camera.

Leave a Reply

Your email address will not be published. Required fields are marked *