Install Official XXMC3 Android 4.1.2 Jelly Bean Firmware on Galaxy Tab 7.0 Plus P6200

Samsung Galaxy Tab 7.0 Plus P6200 can be updated to XXMC3 Android 4.1.2 Jelly Bean for Austria and soon it will be rolled out to other regions. If you haven’t installed the firmware via Kies Software, manual installation of firmware is mentioned below. To flash firmware on Galaxy Tab 7.0 Plus P6200 Odin is used.

P6200XXMC3 Android 4.1.2 Jelly Bean firmware for Galaxy Tab 7.0 Plus P6200 is an official firmware update by Samsung and your device will lose root. Galaxy Tab Plus 7.0 P6200 can be rooted later.

Firmware Details:

PDA: P6200XXMC3
CSC: P6200OXAMC3
Version: 4.1.2
Date: 2013 March

The guide mentioned below is only for Galaxy Tab 7.0 Plus P6200 and is not compatible with any other device. To know the model number of your device go to Settings >> About Tablet.

We cannot be held liable of any damage done to your device while following the below mentioned procedure.

Galaxy Tab 7.0 Plus P6200

Install official XXMC3 Android 4.1.2 Jelly Bean firmware on Galaxy Tab 7.0 Plus P6200

Take a complete backup of data,apps and settings as the procedure may wipe your data.

Make sure that the battery of device has a minimum charge of 60%.

Enable “USB debugging” on your device by going to Settings >> Developer options >> Enable USB debugging.

Download Kies Software to install drivers.

Download XXMC3 Android 4.1.2 firmware (P6200XXMC3_P6200OXAMC3_ATO.zip) update on Galaxy Tab 7.0 Plus P6200 and Odin (Odin307.zip).

Extract the Firmware file which you have downloaded in above step. You will get “.tar” file along with other files.

Extract Odin to get “Odin3 v3.07.exe” file.

Switch off device.

Boot device into download mode. Press and hold Volume Down, Home, Power till device turns on and then press Volume Up to enter download mode.

Connect device to computer using USB cable. Odin will detect your device and ID:COM will turn yellow and a message appears saying “Added”. Re-install drivers if Odin fails to detect device.

Click on “PDA button” in Odin and navigate to select “.tar″ file which you have downloaded.

In Odin make sure that “Auto Reboot” and “F.Reset Time” are selected and “Re-Partition” check box is unchecked.

Click on Start button in Odin to start flashing Android 4.1.2 firmware. When flashing is complete you will get a PASS message.

Disconnect device from your computer and let it boot automatically.

XXMC3 Android 4.1.2 Jelly Bean firmware on Galaxy Tab 7.0 Plus P6200 is installed. You can check firmware version by going to Settings >> About Tablet.

Leave a Reply

Your email address will not be published. Required fields are marked *