Install official XXCMJ2 Android 4.1.2 Jelly Bean firmware on Galaxy Note 10.1 N8000

XXCMJ2 Android 4.1.2 Jelly Bean firmware update for Galaxy Note 10.1 N8000 users in Ukraine is available for a download. You can install the latest firmware on your device via Kies Software. If you want to manually install firmware N8000XXCMJ2 Android 4.1.2 on Galaxy Note 10.1 N8000, go through the step by step guide mentioned below. Since, this is an official firmware update by Samsung your device will lose root. Galaxy Note 10.1 N8000 can be rooted on official firmware later. Odin is used to flash firmware on device.

Firmware Details:

Version: 4.1.2

The guide mentioned below is only for Galaxy Note 10.1 N8000 and is not compatible with any other device. To know the model number of your device go to Settings >> About Tablet.

We cannot be held liable of any damage done to your device while following the below mentioned procedure.

Galaxy  Note 10.1

Install official XXCMJ2 Android 4.1.2 Jelly Bean firmware on Galaxy Note 10.1 N8000

Take a complete backup of data,apps and settings as the procedure may wipe your data.

Make sure that the battery of device has a minimum charge of 60%.

Enable “USB debugging” on your device by going to Settings >> Developer options >> Enable USB debugging.

Download Kies Software to install drivers.

Download XXCMJ2 Android 4.1.2 firmware ( update on Galaxy Note 10.1 N8000 and Odin (

Extract the Firmware file which you have downloaded in above step. You will get “.tar” file along with other files.

Extract Odin to get “Odin3 v3.07.exe” file.

Switch off device.

Boot device into download mode. Press and hold Volume Down, Home, Power till device turns on and then press Volume Up to enter download mode.

Connect device to computer using USB cable. Odin will detect your device and ID:COM will turn yellow and a message appears saying “Added”. Re-install drivers if Odin fails to detect device.

Click on “PDA button” in Odin and navigate to select “.tar″ file which you have downloaded.

In Odin make sure that “Auto Reboot” and “F.Reset Time” are selected and “Re-Partition” check box is unchecked.

Click on Start button in Odin to start flashing Android 4.1.2 firmware. When flashing is complete you will get a PASS message.

Disconnect device from your computer and let it boot automatically.

XXCMJ2 Android 4.1.2 Jelly Bean firmware on Galaxy Note 10.1 N8000 is installed. You can check firmware version by going to Settings >> About Tablet.

Leave a Reply

Your email address will not be published. Required fields are marked *