Install Official XWLSH Android 4.1.2 Firmware on Galaxy S2 I9100

I9100XWLSH Android 4.1.2 Jelly Bean update for Galaxy S2 I9100 users in Australia is being rolled out by Samsung. The new firmware comes mainly with bugs fixes. XWLSH Android 4.1.2 is an official firmware update by Samsung, your device will lose root. You can always root your device later. Odin will be used to flash the firmware on Galaxy S 2 I9100. Keep your device updated by installing the latest firmware by going through the guide of manual installation mentioned below. Earlier, I9100ZSLSE Android 4.1.2 Jelly Bean firmware for Galaxy S2 I9100 for China was released.

Firmware Details:

Version: 4.1.2
Date: February, 2013

The guide mentioned below is only for Galaxy S 2 I9100 and is not compatible with any other device. To know the model number of your device go to Settings >> About Phone.

We cannot be held liable of any damage done to your device while following the below mentioned procedure.

Galaxy S 2

Install official XWLSH Android 4.1.2 firmware on Galaxy S2 I9100

Take a complete backup of data,apps and settings as the procedure may wipe your data.

Make sure that the battery of device has a minimum charge of 60%.

Enable “USB debugging” on your device by going to Settings >> Developer options >> Enable USB debugging.

Download Kies Software to install drivers.

Download XWLSH Android 4.1.2 firmware ( update on Galaxy S2 I9100 and Odin (

Extract the Firmware file which you have downloaded in above step. You will get “.tar” file along with other files.

Extract Odin to get “Odin3 v3.07.exe” file.

Switch off device.

Boot device into download mode. Press and hold Volume Down, Home, Power till device turns on and then press Volume Up to enter download mode.

Connect device to computer using USB cable. Odin will detect your device and ID:COM will turn yellow and a message appears saying “Added”. Re-install drivers if Odin fails to detect device.

Click on “PDA button” in Odin and navigate to select “.tar″ file which you have downloaded.

In Odin make sure that “Auto Reboot” and “F.Reset Time” are selected and “Re-Partition” check box is unchecked.

Click on Start button in Odin to start flashing Android 4.1.2 firmware. When flashing is complete you will get a PASS message.

Disconnect device from your computer and let it boot automatically.

XWLSH Android 4.1.2 firmware on Galaxy S2 I9100 is now installed. You can check firmware version by going to Settings >> About Phone.

No Responses to “Install Official XWLSH Android 4.1.2 Firmware on Galaxy S2 I9100”

Leave a Reply

Your email address will not be published. Required fields are marked *