Install Official UEUCMA3 Android 4.1.2 Jelly Bean Firmware On Galaxy Note 10.1 N8013

Galaxy Note 10.1 N8013 can be updated to UEUCMA3 Android 4.1.2 for Cellular South subscribers in US. You can install UEUCMA3 Android 4.1.2 on Galaxy Note 10.1 N8013 manually.

Firmware Details:

Country/Carrier: Cellular south
PDA: N8013UEUCMA3
CSC: N8013XARCMA3
Version: 4.1.2

The guide mentioned below is only for Galaxy Note 10.1 N8013 and is not compatible with any other device. To know the model number of your device go to Settings >> About Phone.

We cannot be held liable of any damage done to your device while following the below mentioned procedure.

Galaxy  Note 10.1

Install official UEUCMA3 Android 4.1.2 Jelly Bean firmware on Galaxy Note 10.1 N8013

Take a complete backup of data,apps and settings as the procedure may wipe your data.

Make sure that the battery of device has a minimum charge of 60%.

Enable “USB debugging” on your device by going to Settings >> Developer options >> Enable USB debugging.

Download Kies Software to install drivers.

Download XXBMA3 Android 4.1.2 firmware ( N8013UEUCMA3_N8013XARCMA3_XAR.zip) update on Galaxy Note 10.1 N8013 and Odin (Odin307.zip).

Extract the Firmware file which you have downloaded in above step. You will get “.tar” file along with other files.

Extract Odin to get “Odin3 v3.07.exe” file.

Switch off device.

Enable “USB debugging” on your device by going to Settings >> Developer options >> Enable USB debugging.

Switch off device.

Boot device into download mode. Press and hold Volume Down, Home, Power till device turns on and then press Volume Up to enter download mode.

Connect device to computer using USB cable. Odin will detect your device and ID:COM will turn yellow and a message appears saying “Added”. Re-install drivers if Odin fails to detect device.

Click on “PDA button” in Odin and navigate to select “.tar″ file which you have downloaded.

In Odin make sure that “Auto Reboot” and “F.Reset Time” are selected and “Re-Partition” check box is unchecked.

Click on Start button in Odin to start flashing Android 4.1.2 firmware. When flashing is complete you will get a PASS message.

Disconnect device from your computer and let it boot automatically.

UEUCMA3 Android 4.1.2 Jelly Bean firmware on Galaxy Note 10.1 N8013 is installed. You can check firmware version by going to Settings >> About Phone.

Leave a Reply

Your email address will not be published. Required fields are marked *