Install ClockworkMod Recovery On AT&T Galaxy S3

Install ClockworkMod recovery on AT&T Galaxy S3 so that you can install custom ROMs. In this post we will go through guide to install ClockWorkMod recovery on AT&T Galaxy S3.

The ROM and guide mentioned below below is only AT&T Galaxy S3 and does not supports any other variant. You can check your device model by going to Settings >> About Phone.

We cannot be held liable for any loss of data or damage done to device while following the below mentioned guide.

Install ClockworkMod Recovery on AT&T Galaxy S3

Take a complete backup of data,apps and settings as the procedure may wipe your data.

Make sure that the battery of device has a minimum charge of 60%.

Download and install drivers on your device from here

Download Odin 3.04 and extract “” file on your computer.

Download the ClockworkMod recovery file. Filename- clockworkmod.tar

Switch off device and boot into download mode. Press Volume down and Home buttons alonng with Power buttons till you get a Warning message. Press Power button again to enter into download mode.

Launch Odin by clicking on “Odin3 v3.04.exe” file which you got after extracting file.

Connect your device to computer via USB Cable. ID:COM box will turn Yellow which means that Odin has detected your device.

In Odin click on “PDA” and select “clockworkmod.tar file” which you have downloaded in earlier step.

Click on “Start” button to start installing TWRP recovery on your device. Once installation is complete your device will boot automatically.

ClockworkMod recovery is installed on your AT&T Galaxy S3.


No Responses to “Install ClockworkMod Recovery On AT&T Galaxy S3”

Leave a Reply

Your email address will not be published. Required fields are marked *