Install Android 4.2.2 Jelly Bean Omega ROM on Galaxy S4 I9500

Samsung Galaxy S4 will be launched globally in few days. XDA forum members have already released Custom ROMs for Galaxy S4 I9500, we will be going through the guide to install Omega Android 4.2.2 Jelly Bean ROM on Galaxy S4 I9500. Omega ROM is based on firmware XXUAMDA Android 4.2.2. This is a Custom ROM and not an official ROM update from Samsung.

The guide mentioned below is only for Galaxy S4 I9500 and cannot be tried on any other device or variant. You can check device model by going to Settings >> About phone.

We cannot be held liable of any damage done to your device while following the below mentioned procedure.

Omega ROM

Install Android 4.2.2 Jelly Bean Omega ROM on Samsung Galaxy S4 I9500

Take a complete backup of data,apps and settings as the procedure may wipe your data.

Make sure that the battery of device has a minimum charge of 60%.

Enable “USB debugging” on your device by going to Settings >> Developer options >> Enable USB debugging.

ClockworkMod Recovery should be installed. Guide to install ClockworkMod Recovery on Galaxy S4 I9500.

Download the latest version of ROM from source page here.

Extract the zip file to SD-card of your device without extracting.

Switch off device and boot into recovery. Hold power button and volume down button and enter recovery.

Perform a Nandrop backup of your existing ROM. Select “Backup and Restore” and then select “Backup again”.

Select “wipe data/factory reset” and wait till the data gets wiped completely. Click on “Advanced” and wipe off Dalvik cache.

Select “install zip from sdcard” and then select “choose zip from sdcard”. Navigate to “Omega ROM” file which you have downloaded and confirm to “install”. Wait till it gets installed.

Select “reboot system now”.

You have installed Omega ROM based on Android 4.2.2 on Galaxy S4 I9500.

No Responses

Leave a Reply