Install Android 4.1 Jelly Bean TurkBeyROM On Samsung Galaxy S3

Samsung Galaxy S3 users can now install TurkbeyROM based on official Android 4.1 Jelly Bean XXDLIB firmware. XDA Senior Member turkbey has released a Custom ROM named as TurkbeyROM. We will be going through the guide to install the Custom ROM on Samsung Galaxy S3.

The guide mentioned below is only for Galaxy S3 I9300 and not for any other device. You can check your device model number by going to Settings >> About Phone.

We cannot be held liable of any damage done to your device while following the below mentioned procedure.

Install Android 4.1 Jelly Bean TurkBeyROM on Samsung Galaxy S3

Take a complete backup of data,apps and settings as the procedure may wipe your data.

Make sure that the battery of device has a minimum charge of 60%.

Enable “USB debugging” on your device by going to Settings >> Developer options >> Enable USB debugging.

Install ClockworkMod Touch Recovery 6 on Galaxy S3.

Download TurkBeyROM from here and copy the file to SD-Card of your device without extracting.

Switch off device and enter into recovery mode. Press and hold the Volume Up and Volume Down and Power buttons.

Perform a Nandrop backup of your current ROM. Select Backup and Restore option from the recovery mode and then select backup again.

Select the option “wipe data/factory reset” and confirm to wipe all data. Wait till data gets wiped. Select Advance and select “Wipe Dalvik Cache” to delete cache.

Select “install zip from sdcard” and then select “choose zip from sdcard”. Go to the ROM file on the SD card which you have installed in the earlier step and select to install.

Once installation is complete, select “go back” and then select “reboot system now”.

Android 4.1 Jelly Bean TurkBeyROM on Samsung Galaxy S3 is installed.


Leave a Reply

Your email address will not be published. Required fields are marked *